DIRECTIONS FOR USE It is a violation of Federal law to use this product in a manner inconsistent with its labeling. Read entire label before using this product. Do not apply this product in a way that will contact workers or other persons, either directly or through drift. Only protected handlers may be in the area during application. For any requirements specific to your State or Tribe, consult the State or Tribal agency responsible for pesticide regulation. When using Rampart fungicide with Pentra-Bark, adhere to applicable label directions. Only use Pentra-Bark with basal bark or tree injection applications. GENERAL APPLICATION INSTRUCTIONS Apply Rampart Fungicide by various application methods, including foliar sprays, trunk injection*, soil drench, soil incorporation, basal bark application, and bare root dip. For foliar sprays, apply Rampart Fungicide with sufficient water for adequate coverage of foliage, according to crop and growth stage. To insure good coverage, spray to wet. GENERAL APPLICATION INSTRUCTIONS (TRUNK INJECTION ONLY*) Rampart Fungicide is a systemic fungicide for the prevention and treatment of Downy mildew, Sudden oak death (Phytophthora ramorum), root rots (Phytophthora spp.), Pythium and various other disease of agricultural trees, indoor and outdoor ornamentals, forestry applications including domestic trees, conifers, pines and oaks. This product may be applied up to the day of harvest. MIXING INSTRUCTIONS 1. Fill the spray tank with 1/2 of the required volume of water. 2. Add Rampart Fungicide slowly to the tank and agitate by hydraulic or mechanical means. 3. Continue to fill the tank with water to the desired volume while agitating. 4. Continue agitation when applying. For 1.0 gallon (3.785 liters) container sizes: this package can treat up to 34,848 square feet at the maximum treatment rate. For 2.5 gallons (9.463 liters) container sizes: this package can treat up to 2 acres at the maximum treatment rate. For 5.0 gallons (18.925 liters) container sizes: this package can treat up to 4 acres at the maximum treatment rate.. COMPATIBILITY Mixing Rampart Fungicide with certain surfactants, foliar fertilizers or other pesticides may cause crop injury. Rampart Fungicide is a slightly acidic buffer solution. Avoid mixing Rampart Fungicide with strongly acidic or alkaline materials. Do not tank mix without first testing the mixture’s compatibility nor apply it without assessing its safety to the crop (phytotoxicity). It is not possible to test all material combinations and environmental tank mix combinations. Always conduct a test with the intended tank mix on a small area prior to any large scale applications. To determine if a combination is phytotoxic to a specific crop, spray a small area of foliage and fruit, and then evaluate 3 to 7 days later for visual symptoms. Test the compatibility of spray adjuvants (i.e. stickers, spreaders, wetting agents) with Rampart Fungicide before use. Do not use acidifying type compatibility agents. To determine the compatibility of Rampart Fungicide with other products, use a jar compatibility test. Add the correct proportions of each product and the appropriate quantity of water to clean container, thoroughly mix, then let stand for 3 to 5 minutes. If the mixture remains in solution or can be remixed readily, the products are considered compatible. Compatability (Trunk Injection Only*): Use only Rampart Fungicide alone when used as a trunk injection. To avoid undesirable phytotoxicity, do not apply Rampart Fungicide to trees treated with other pesticides or copper based compounds at intervals less than 20 days, unless instructed to do so by your consultant.